EasyCork 1.75mm Light 500 gram

$89.98$158.00 (-43%)

5 in stock

SKU: AST-18571 Category:

Calculate Shipping

Estimated Arrival*:

Metro area: 3-7 working days
Regional area: 5-9 working days
Rural area: 6-12 working days
EasyCork is a lightweight cork-filled PLA-based filament which is gravimetrically filled with approximately 30% cork fibres. The gravimetric filling with relatively lightweight cork fibres means that EasyCork has extremely high volumetric cork filling properties, allowing you to 3D print beautiful objects with great cork-like aesthetics and cork-like properties such as being lightweight and impact resistant.
EasyCork is a very easy to print material as it is based on our EasyFil PLA compound and the 30% gravimetrical filling with cork fibres make the filament absolutely warp-free.

Unique features

  • High cork filling
  • Real cork feel, look and smell
  • Very easy to print
  • Warp-free printing
  • Great thermal stability and filament flowing behaviour
  • Perfect first- and inter-layer adhesion
  • Can be printed at high printing speeds
  • Lightweight and impact resistant

General printing guidelines

Nozzle size: ≥ 0.15mmLayer height: ≥ 0.20mmFlow rate: ± 100%
Print temp: ± 210 – 260° CPrint speed: HighRetraction: Yes ± 5mm
Heat bed: ± 0 – 60° CFan speed: 50-100%Experience level: Beginner

Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

 Filament length

ρ: 1.027 g/cc50 gr coil0.5 Kg spool
Ø 1.75mm± 20.2m± 202m
Ø 2.85mm± 7.6m± 76m

 Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

 Product export information

HS Code:DescriptionCountry of origin


This filament is compliant to below listed directives and regulations.

  • RoHS directive 2011/65/EC
  • REACH directive 1907/2006/EC

This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.


Additional information
Dimensions20.5 × 21 × 6.5 cm
Be the first to review “EasyCork 1.75mm Light 500 gram”

Your email address will not be published. Required fields are marked *


There are no reviews yet.

Shop By Categories

EasyCork 1.75mm Light 500 gram

$89.98$158.00 (-43%)

Add to Cart